Double-Wide Mobile Home Moving
Professional splitting, transport, and reassembly of double-wide manufactured homes. Multi-state permits, pilot car escorts, and full setup at the destination — handled by one experienced crew across 30+ states.
Moving a double-wide manufactured home is one of the most complex transport operations in the mobile home industry. Unlike single-wide moves, a double-wide must be professionally separated into two halves, each transported on its own trailer with its own oversize permit and escort vehicles, then reassembled and rejoined at the new site.
Interstate Mobile Home Movers specializes in double-wide relocations across 30+ states — including Texas, Virginia, Florida, and the entire East Coast. We handle every step from the initial disconnect through final setup, so you get a move-in ready home at the destination.
The Double-Wide Moving Process
Disconnect & Prep
Utilities disconnected, skirting removed, interior braced, marriage wall separated. Each half prepared for independent transport.
Permits & Route
Separate oversize permits filed for each section in every state on the route. Escort vehicles scheduled, utility coordination confirmed.
Split Transport
Each half loaded onto its own trailer and transported separately with pilot car escorts — front and rear for loads over 16 ft wide.
Rejoin & Setup
Sections positioned on-site, marriage wall sealed, leveling completed, blocking and tie-downs installed, skirting and utilities reconnected.
What’s Included in Every Double-Wide Move
Pre-Move Services
- On-site inspection and measurement of your double-wide
- Utility disconnect coordination (electric, water, gas, sewer)
- Skirting removal and storage or disposal
- Interior bracing to prevent drywall and cabinet damage in transit
- Marriage wall separation by trained crew
- Transport axle installation on each section
Transport & Logistics
- Separate oversize-load permit for each half (e.g. $40 per section in Texas via TxDMV)
- Multi-state permit coordination for interstate moves
- Route surveys — bridge clearances, overhead utilities, turning radii
- Certified pilot car escorts (1 for loads 12–14 ft wide; 2 for loads over 16 ft)
- Utility line raise/lower coordination along the route
- Daytime-only transport per state regulations
Setup at Destination
- Sections positioned and aligned on the new foundation
- Marriage wall sealed and weatherproofed
- Blocking, leveling, and pier adjustment
- Tie-down and anchor installation per state code
- Skirting installation assistance
- Utility reconnect coordination
- Final walk-through and leveling verification
Why Double-Wide Moves Require Specialists
Two Loads, Two Permits
Each half of a double-wide is a separate oversize load requiring its own permit, its own trailer, and its own escort vehicles. That’s double the coordination of a single-wide move.
Marriage Wall Integrity
The center seam where two halves meet — the marriage wall — must be separated without damaging structural framing, electrical runs, or plumbing, then perfectly realigned at the destination.
Width Creates Route Challenges
Double-wide sections are typically 14–16+ feet wide. At that width, many roads, bridges, and intersections require advance route surveys, utility coordination, and police escorts.
Reassembly Precision
The two halves must align within fractions of an inch for the marriage wall seal, roof line, and floor to match. This requires experienced crews with hydraulic leveling equipment.
Need a Double-Wide Moved?
From Virginia to Texas and everywhere in between — we split, transport, and reassemble double-wide homes with full permit coordination and setup. One team, one quote, no surprises.
Request Your Free Estimate Or call us directly: (434) 202-4614Double-Wide Home Types We Transport
Standard Double-Wide
The most common configuration — two sections, each 12–16 feet wide, joined at a center marriage wall. Typical sizes include 24×40, 28×52, 28×60, and 32×60.
Older Double-Wide Homes
Pre-HUD (before 1976) double-wides require extra care during separation and transport. Our crews assess structural condition before committing to the move.
Multi-Section Modular
Some modular homes use a similar multi-section design. We transport these using the same split-and-rejoin process, with permit specs adjusted for the dimensions.
Triple-Wide Homes
Three-section homes require three separate trailers, three permits, and additional escort coordination. We handle triple-wides on a case-by-case basis — contact us to discuss.
How Much Does It Cost to Move a Double-Wide?
Double-wide moves cost more than single-wides because of the split transport requirement — two trailers, two permits, two escort teams, plus reassembly labor at the destination.
Typical ranges:
- Local moves (under 50 miles): $3,000 – $10,000
- Regional moves (50–200 miles): $6,000 – $15,000
- Interstate long-haul (200+ miles): $10,000 – $25,000+
- Per-mile rate: $8 – $15 per mile (after base fee)
- Setup at destination: $3,000 – $7,000 (included in full-service quotes)
Every quote is custom — cost depends on home dimensions, distance, number of states on the route, site conditions at both locations, and services needed. We provide free written estimates with no hidden fees. Request your free double-wide quote.
Double-Wide Moving Questions
Can a double-wide be moved in one piece?
In most cases, no. Double-wides are too wide to transport as a single unit on public roads. They must be separated into two halves, each transported on its own trailer with its own oversize permit. The only exception is very short on-property moves where no public roads are involved.
How long does a double-wide move take?
Local double-wide moves typically take 2–3 days (one day for disconnect and split, one for transport, one for reassembly). Interstate moves take 3–5+ days depending on distance and permit processing time. We give you a detailed timeline with your quote.
Do I need two separate permits for a double-wide?
Yes — each half requires its own oversize-load permit in every state on the route. In Texas, for example, each section needs a $40 TxDMV manufactured housing single-trip permit. We handle all permit coordination as part of your move.
Will my home be damaged during the split?
When handled by experienced crews, damage during separation is minimal. We brace interiors, protect marriage wall connections, and use established procedures. Minor cosmetic repairs at the seam (caulking, trim) are normal and expected after reassembly.
Can you move a double-wide across state lines?
Yes — interstate double-wide transport is our specialty. We coordinate permits, escorts, and route surveys for every state on the route. We regularly move double-wides between Virginia, North Carolina, Texas, Florida, and all 30+ states we serve.
Do you handle setup and leveling at the new site?
Yes. Our full-service double-wide moves include reassembly, marriage wall sealing, leveling, blocking, tie-downs, skirting assistance, and utility reconnect coordination. Your home is move-in ready when we leave. See our safety and insurance page for details on how your move is protected.
Ready to Move Your Double-Wide?
Tell us the home size, pickup location, and destination. We’ll send you a detailed, no-obligation quote — usually within 24 hours.
Get Your Free Quote TodayOr call (434) 202-4614
Explore More Services
📍 Services: All Services · Mobile Home Moving
📍 States: Texas · Virginia · Florida · North Carolina · South Carolina · Maryland · Washington DC
📍 Company: About Us · Get a Quote · Contact · Service Areas · FAQ
🔗 External: FMCSA Regulations